forum.vdsworld.com

Rubes_sw · Posted: Tue Jan 09, 2007 2:35 pm Post subject: Table Bug

Is it me or is there sometimes a bug when trying to use LIST PUT with the table element ?

I'm having lots of fun (NOT) with trying to use DBLCLICK on the table element, editing the data and then using the list put command to update the table.

Any one else have any probs like this ?

Nathan

vdsalchemist · Posted: Tue Jan 09, 2007 3:09 pm Post subject:

Nathan,
I have ran into this same issue. My work around was to use List Insert and then delete the item below. This should give you the same result as List Put. What is strange is that List Put will sometimes work and sometimes not. Also make sure your not playing with the Field Seperator. The table element hates that.

Garrett · Posted: Wed May 28, 2014 11:27 pm Post subject:

I might be a few years late on this thread, but I believe I may have finally found the problem to this one.

I was running into the same problem as you two, tried using PUT only to have it not work properly... DragonSphere mentions the field sep, and I was doing some changes to the field sep prior to trying to use PUT on the TABLE. But! If I change the field sep back to the pipe character right before using PUT on the TABLE, PUT works with no problem on the TABLE.

At least, this is what is currently working for me here right now.

~Garrett
(NECRO-POSTING FTW!)

LiquidCode · Posted: Fri May 30, 2014 5:02 pm Post subject:

A few years late? lol